How much material is wasted on supports?

Supports typically use 10-30% extra material depending on the model geometry. Tree supports in modern slicers use significantly less material than traditional linear supports.

What is a normal failure rate?

A well-tuned printer should have a failure rate under 5%. New users might experience 10-20% until they learn optimal settings. High failure rates usually indicate calibration issues.

Purge lines (skirts, prime lines) are printed at the start of each print to prime the nozzle. They typically use 0.3-0.5g of filament per print. It is small but adds up over many prints.

3DPrintCalcs

Material Waste Calculator — Failed Prints & Supports

Estimate wasted material from failed prints, supports and purge lines.

Filament per Print

Support Material

Failure Rate

Prints per Month

Purge Line Length

Include purge waste

How We Calculate This

Formula

Support waste = Filament per print x Support percentage
Failure waste = Filament per print x Failure rate
Purge waste = Purge line length x 0.012 g/mm
Total waste = Support + Failure + Purge waste

The purge weight is based on a typical 0.4mm nozzle extruding a 0.2mm layer height purge line.

Frequently Asked Questions

Related Calculators

Print Cost Calculator

Calculate total print cost including material, electricity and machine wear.

Electricity Cost Calculator

Estimate the electricity cost of a print based on wattage and duration.

Time vs Quality Calculator

Compare print time at different layer heights and speed settings.

Batch Printing Calculator

Calculate time and cost savings from printing multiple parts in one batch.

Printer ROI Calculator

Calculate how quickly your printer pays for itself based on usage.

Last updated: February 2026

All calculations are estimates. Always verify settings with test prints before committing to final prints.